Classic Lodestar Small Frame - Protector Kit

The Protector is designed to allow the intermediate gear to slip on an excessive overload.
Classic Lodestar Hoist Parts - Small Frame Protector Kit
KEY # PART # DESCRIPTION QTY
627-120 27029B Gear Housing 1
627-122 28830 Gear Housing Attaching Screw 4
627-122A 940802 Gear Housing Attaching Screw Lockwasher 4
627-124 27747 Gear Housing Gasket 1
627-303 27009 Liftwheel Gear (Model B & F) 1
  27010 Liftwheel Gear (Model C) 1
627-304 27767 Liftwheel Gear Snap Ring 1
627-307 88429 Liftwheel Bearing - Gear End 1
627-310 27653 Drive Shaft & Pinion Sub Assembly (Model B) (inc. 627-311 to 627-315) 1
  27654 Drive Shaft & Pinion Sub Assembly (Model C & F)  (inc. 627-311 to 627-315) 1
627-311 24641 Drive Shaft & Pinion (Model B) 1
  24642 Drive Shaft & Pinion (Model C & F) 1
627-312 82009 Drive Shaft Pinion Bearing 1
627-313 27710 Drive Shaft Bearing Spacer 1
627-314 27851 Brake Hub (Model B) 1
  27852 Brake Hub (Model C & F) 1
627-315 27766 Brake Hub Snap Ring 1
627-321 82009 Intermediate Gear & Pinion Bearing - Outboard 1
627-322 27712 Limit Switch Drive Pinion 1
627-323 27765 Intermediate Gear Snap Ring 1
627-325 28623 Intermediate Pinion (Model B & F) (inc. 627-322) 1
  28624 Intermediate Pinion (Model C) (inc. 627-322) 1
627-326 88440 Intermediate Gear & Pinion Bearing - Inboard 1
627-327 28694 Lodestar Protector (Model B) 1
  28695 Lodestar Protector (Model C & F) 1
627-328 2878 Lodestar Protector Kit (Model B) (inc. 627-124, 627-321, 627-323, 627-325, 624-327) 1
2879 Lodestar Protector Kit (Model C) (inc. 627-124, 627-321, 627-323, 627-325, 624-327)
  2880 Lodestar Protector Kit (Model F) (inc. 627-124, 627-321, 627-323, 627-325, 624-327) 1

INSPECTION

To assure safe operation, extra long life and top performance, a regular inspection procedure must be initiated to replace damaged parts.

MAINTENANCE

The Protector should operate for the normal life of the hoist without service.
This device has been lubricated and calibrated at the factory for a specific model of a hoist. It is not adjustable or interchangeable.
For proper overload protection, be sure before installing a Protector that it is correct for the unit. The spring washer of the Protector had been color-coded at the factory. Please refer to the CM hoist replacement parts user manual - Classic Lodestar (p.11)
CAUTION: The Protector is susceptible to overheating and wear when slipped for extended periods. Under no circumstance should the clutch be allowed to slip for more than a few seconds. Due to the above, a hoist equipped with a Protector is not recommended for use in any application where there is a possibility of adding to an already suspended load to the point of overload. This includes dumbwaiter installations, containers that are loaded in mid-air, etc. 
Go Back to
Full Classic Lodestar Hoist Configuration