Prolyte HT Tower
- Upgrade on the MPT Tower. Based on H30V truss sections with a new fully bolted HT-010 sleeve block.
- CCS6 connection. The sleeve block fits 40 square series truss on all four sides with bolted male or female CCS6 couplers.
- Adapter plate option. Use the sleeve block with H40R or H30V truss while maintaining full truss capacity.
- Dead hang pin. Placed through the sleeve block in a 50 cm H30V tower section; quick, lightweight and protects against uplift.
Accepted payment methods
shipping
HT Tower
With the introduction of the HT Tower, Prolyte has an upgrade on the MPT Tower. The HT tower is based on H30V truss sections and employs a new type of sleeve block that fits the 40 square series truss on all four sides by means of bolted CCS6 couplers (either male or female).
In combination with an adapter plate, it is also possible to use the sleeve block with either H40R or H30V truss, to maintain the full capacity of the truss. The HT sleeve module is a fully bolted structural element with threaded holes on all 4 sides for eye bolts to take guywires.
The HT tower also has a new dead hang solution. The dead hang of the system can now be done by a dead hang pin which will be placed through the sleeve block in a special H30V tower section with a length of 50 cm. This dead hang solution is quick, lightweight, easy to attach and also protects your system against uplift. The top section (MPT-009S) and base section (MPT-004) can facilitate the use of either a hand winch or a chain hoist.
HT tower components
- HT-010: sleeve module
- HT-DH-PIN: dead hang pin
- H30V-L050-HT-DH: 50 cm H30V dead hang truss section