Classic Lodestar Small Frame - Limit Switch Parts

With hoists that are equipped with an adjustable screw limit switch, the limit switch is able to automatically stop the hook at any predetermined point when either hoisting or lowering.
Classic Lodestar Hoist Parts - Small Frame Limit Switch
KEY # PART # DESCRIPTION QTY
627-220 27749 Limit Switch Shaft & Gear Kit - Rotatable 1
27561 Limit Switch Shaft & Gear Kit - Non-Rotatable
627-222 31631 Limit Switch Kit 1
627-231 27502 Limit Switch Bracket Sub-Assembly 1
627-125 27625 Back Frame 1

Hoist Limit Switch

A couple of hoist troubles are caused by a hoist limit switch:

  • Hook does not respond to the control station or control device.
  • Hook lowers but does not raise.
  • Hook raises but does not lower.
  • Hook fails to stop at either or both ends of travel.
  • Hook stopping point varies.

It is always recommended to refer to CM hoist replacement parts user manual - Classic Lodestar for resolving the issues.

Caution: DO NOT use limit switches as routine operating stops. They are emergency devices only

Extended Limit Switch Parts

The parts listed above are for a standard 44 thread per inch limit switch shaft. Using this assembly, Model B & F hoists can achieve a maximum lift of 102 feet, while Model C hoists have a maximum lift of 206 feet. The limit switch assembly can be modified with a 56 thread per inch shaft or a 64 thread per inch shaft to increase the maximum lift.

To replace the stock limit switch shaft with a 56 TPI shaft, you will need a 56 TPI Limit Switch Shaft, a Limit Switch Shaft Gear and a 56 TPI Limit Switch Nut.  This allows a maximum lift of 133 feet for Model B & F hoists and 262 feet for Model C hoists.

A 64 TPI Limit Switch Shaft is also available and requires a Gear and 56 TPI Nut to complete the assembly.  This assembly increases the maximum lift of Model B & F hoists to 152 feet, and allows Model C hoists a maximum lift of 299 feet.

Go Back to
Full Classic Lodestar Hoist Configuration